Language
Model:
CMS-10
Intelligent Vacuum Suction Module 10
As low as
$78.24
The CMS-10 standard module system is a modular tool system. Due to the compact design of the product, it is very space-saving in size. The CMS-10 standard module has a width of 10, and can be extended in increments like a building block. It can be used exclusively for the soft board or IC version in the 3C industry. CMS-10 series dedicated 3C design, specifically to absorb high and low 3C products, PCB board IC board panel small originals, etc. ... sponge thickness is fixed for 5mm for the mainstream Currently based on two models, CMS-4510 and CMS-7010 CMS-10
Features
- Space-saving in design
- Specializes in 3C industry for the use of flexible boards or IC boards
- Suitable for any industry
- high and low thickness can reach up to 3.5mm
- Can be used with a vacuum pump & a vacuum cylinder or with a vacuum generator
- Use and Applications
- Long IC board Convex Suction
- Long LED Lighting Strip Convex Suction
- IC Board Convex Suction
- Mobile Surface Suction
Availability:
In stock
Only %1 left
SKU
CMS-10
| Name | Version | Size | Download |
|---|---|---|---|
| RZN Catalog | 1.0 | 22.3 MB |  |
Frequently Asked Questions
Q1: How to measure the data of claw repetition precision 0.01?
A1: This data is the average of one million tests.
Q2: The service life of the gripper and the tolerance of the slide rail?
A2: There is no standard data value and it will vary depending on the environment and mode of use.
Q3: Why is there no standard Finger at the front end of the gripper body?
A3: All fingers are custom made and must be customized according to the customer's function.
Q4: How many points can the gripper be equipped with at most?
A4: 4 sensing points, including 2 reed switches and 2 advanced switches.
Q5: Can the gripper be moved alone?
A5: No, RGN/RZN series grippers are all in the same motion.
Q6: What is the maximum temperature that the gripper can withstand?
A6: 70-80 degrees, high temperature mainly affects the damage of the O-ring in the body.
Q7: Is there any restriction on the length of the Finger of the gripper?
A7: Yes, each model has a limited length. If the limit is exceeded, the wear degree of the gripper slider will be different and the slider will not run normally.
Q8: Does the gripper need maintenance?
A8: Yes, and for a certain maintenance time, but if the use of the environment has dust, iron and aluminum chips, oil pollution... It is recommended to do simple cleaning at high frequency (such as cleaning the slider with an air gun).
| Model | CMS-10 |
|---|
Write Your Own Review